Brand Error Codes Updated: 2026-10-11 9 min read

Samsung Refrigerator Error Codes List: 22E, 33E, 1E & Diagnostic Reset

Samsung French Door and Family Hub refrigerators feature sophisticated self-diagnostics. When error codes flash on your display panel, here is what each code signifies and how our Garland technicians test and clear them.

Factory-Trained Samsung Tech — Refrigerator Repair Garland

Field-verified in Garland, TX

Master Technician Quick Answer (Direct Diagnostic)

Samsung refrigerator error codes point directly to faulty sensors, motors, or communication circuits. The most common code is 22E (Refrigerator Evaporator Fan Motor failure), followed by 33E (Ice Pipe / Fill Tube Heater error) and 1E (Freezer Defrost Sensor fault). A 5-minute breaker power cycle can clear temporary glitches, but recurring codes indicate physical component failure.

Verified for Garland, TX ZIP codes (75040–75046)Need on-site diagnostics? Call (773) 599-5124

Master Samsung Refrigerator Error Code Table

Here are the most common error codes displayed on Samsung French Door (RF28, RF22, RF23) and Side-by-Side (RS) series:

CodeSystem ComponentSymptomTechnical Solution
22EFresh Food Evaporator Fan MotorMain fridge warm; humming or buzzing fan noiseReplace DC evaporator fan motor and inspect fan housing for ice obstruction
33EIce Maker Fill Tube / Water Line HeaterIce maker stops making ice; fill tube frozen solidTest fill tube heater resistance; replace heater or harness
1E / 5EDefrost Sensor Circuit (Freezer / Fridge)Frost buildup; cabinet warming to 50°F+Ohm test 5kΩ thermistor at 77°F; replace defrost sensor harness
25EDefrost Heater / Thermal Fuse FailureEvaporator coils heavily iced overContinuity check on defrost bimetal thermal fuse & tubular calrod heater
40EIce Room Fan Motor ErrorIce maker bucket warm; cubes melt together into solid blockInspect ice room blower duct; replace secondary auger fan
88 88Power Surge Communication ErrorDisplay flashing all segments after storm or blackoutPerform hard power reset; inspect main power supply PCB

How to Hard-Reset a Samsung Refrigerator Display

If your Samsung refrigerator experienced a power flicker or brief Dallas County lightning storm surge, perform this hard reset sequence:

Step 1: Locate your home's dedicated electrical breaker panel and switch off the 15A/20A refrigerator breaker completely.
Step 2: Wait a full 5 to 10 minutes to allow capacitors on the Samsung main PCB and inverter board to discharge fully.
Step 3: Switch the breaker back on. If the error code was a temporary electronic communication glitch, the display will resume normal temperature readings.
Step 4: If the code immediately re-appears or flashes within 2 hours, the onboard microcontroller has confirmed an active sensor or motor open-circuit.

The Samsung 'Ice Under Crisper Drawer' Defrost Issue

One of the most famous Samsung design issues in North Texas is water pooling and freezing into a solid sheet beneath the twin vegetable crisper drawers. This occurs when the factory aluminum drain clip is too short to conduct defrost heat down into the drain hole, allowing the drain to freeze shut.

We install the upgraded Samsung OEM extended drain clip (DA61-06796A) and thermal probe retrofit, permanently resolving the issue so water drains properly into the lower pan instead of your drawers.

Voice Search & Homeowner FAQs

Frequently Asked Questions

Error code 22E indicates that the fresh food section evaporator fan motor is not spinning or the main control board is not receiving feedback RPM signals from the motor hall sensor. The fan motor or wire harness must be replaced.
Same-Day Garland Dispatch

Rather Have an Expert Fix It Today?

Our EPA Section 608 certified technicians carry all replacement fans, defrost heaters, valves, and boards directly in their trucks. Arrival in under 2 hours across Garland.

Related Diagnostic Guides

Garland Techs Ready 2-Hour Arrival Windows